linux/drivers/net/usb/cdc_ether.c

749 lines
22 KiB

2011-04-01 20:12:02 -07:00
qmi_wwan/cdc_ether: let qmi_wwan handle the Huawei E1820 Another QMI speaking Qualcomm based device, which should be driven by qmi_wwan, while cdc_ether should ignore it. Like on other Huawei devices, the wwan function can appear either as a single vendor specific interface or as a CDC ECM class function using separate control and data interfaces. The ECM control interface protocol is 0xff, likely in an attempt to indicate that vendor specific management is required. In addition to the near standard CDC class, Huawei also add vendor specific AT management commands to their firmwares. This is probably an attempt to support non-Windows systems using standard class drivers. Unfortunately, this part of the firmware is often buggy. Linux is much better off using whatever native vendor specific management protocol the device offers, and Windows uses, whenever possible. This means QMI in the case of Qualcomm based devices. The E1820 has been verified to work fine with QMI. Matching on interface number is necessary to distiguish the wwan function from serial functions in the single interface mode, as both function types will have class/subclass/function set to ff/ff/ff. The control interface number does not change in CDC ECM mode, so the interface number matching rule is sufficient to handle both modes. The cdc_ether blacklist entry is only relevant in CDC ECM mode, but using a similar interface number based rule helps document this as a transfer from one driver to another. Other Huawei 02/06/ff devices are left with the cdc_ether driver because we do not know whether they are based on Qualcomm chips. The Huawei specific AT command management is known to be somewhat hardware independent, and their usage of these class codes may also be independent of the modem hardware. Reported-by: Graham Inggs <graham.inggs@uct.ac.za> Signed-off-by: Bjørn Mork <bjorn@mork.no> Signed-off-by: David S. Miller <davem@davemloft.net>
2013-06-06 12:57:02 +02:00
USB: Disable hub-initiated LPM for comms devices. Hub-initiated LPM is not good for USB communications devices. Comms devices should be able to tell when their link can go into a lower power state, because they know when an incoming transmission is finished. Ideally, these devices would slam their links into a lower power state, using the device-initiated LPM, after finishing the last packet of their data transfer. If we enable the idle timeouts for the parent hubs to enable hub-initiated LPM, we will get a lot of useless LPM packets on the bus as the devices reject LPM transitions when they're in the middle of receiving data. Worse, some devices might blindly accept the hub-initiated LPM and power down their radios while they're in the middle of receiving a transmission. The Intel Windows folks are disabling hub-initiated LPM for all USB communications devices under a xHCI USB 3.0 host. In order to keep the Linux behavior as close as possible to Windows, we need to do the same in Linux. Set the disable_hub_initiated_lpm flag for for all USB communications drivers. I know there aren't currently any USB 3.0 devices that implement these class specifications, but we should be ready if they do. Signed-off-by: Sarah Sharp <sarah.a.sharp@linux.intel.com> Cc: Marcel Holtmann <marcel@holtmann.org> Cc: Gustavo Padovan <gustavo@padovan.org> Cc: Johan Hedberg <johan.hedberg@gmail.com> Cc: Hansjoerg Lipp <hjlipp@web.de> Cc: Tilman Schmidt <tilman@imap.cc> Cc: Karsten Keil <isdn@linux-pingi.de> Cc: Peter Korsgaard <jacmet@sunsite.dk> Cc: Jan Dumon <j.dumon@option.com> Cc: Petko Manolov <petkan@users.sourceforge.net> Cc: Steve Glendinning <steve.glendinning@smsc.com> Cc: "John W. Linville" <linville@tuxdriver.com> Cc: Kalle Valo <kvalo@qca.qualcomm.com> Cc: "Luis R. Rodriguez" <mcgrof@qca.qualcomm.com> Cc: Jouni Malinen <jouni@qca.qualcomm.com> Cc: Vasanthakumar Thiagarajan <vthiagar@qca.qualcomm.com> Cc: Senthil Balasubramanian <senthilb@qca.qualcomm.com> Cc: Christian Lamparter <chunkeey@googlemail.com> Cc: Brett Rudley <brudley@broadcom.com> Cc: Roland Vossen <rvossen@broadcom.com> Cc: Arend van Spriel <arend@broadcom.com> Cc: "Franky (Zhenhui) Lin" <frankyl@broadcom.com> Cc: Kan Yan <kanyan@broadcom.com> Cc: Dan Williams <dcbw@redhat.com> Cc: Jussi Kivilinna <jussi.kivilinna@mbnet.fi> Cc: Ivo van Doorn <IvDoorn@gmail.com> Cc: Gertjan van Wingerde <gwingerde@gmail.com> Cc: Helmut Schaa <helmut.schaa@googlemail.com> Cc: Herton Ronaldo Krzesinski <herton@canonical.com> Cc: Hin-Tak Leung <htl10@users.sourceforge.net> Cc: Larry Finger <Larry.Finger@lwfinger.net> Cc: Chaoming Li <chaoming_li@realsil.com.cn> Cc: Daniel Drake <dsd@gentoo.org> Cc: Ulrich Kunitz <kune@deine-taler.de> Signed-off-by: Sarah Sharp <sarah.a.sharp@linux.intel.com>
2012-04-23 10:08:51 -07:00