linux/fs/f2fs/node.h

444 lines
12 KiB

f2fs: fix conditions to remain recovery information in f2fs_sync_file This patch revisited whole the recovery information during the f2fs_sync_file. In this patch, there are three information to make a decision. a) IS_CHECKPOINTED, /* is it checkpointed before? */ b) HAS_FSYNCED_INODE, /* is the inode fsynced before? */ c) HAS_LAST_FSYNC, /* has the latest node fsync mark? */ And, the scenarios for our rule are based on: [Term] F: fsync_mark, D: dentry_mark 1. inode(x) | CP | inode(x) | dnode(F) 2. inode(x) | CP | inode(F) | dnode(F) 3. inode(x) | CP | dnode(F) | inode(x) | inode(F) 4. inode(x) | CP | dnode(F) | inode(F) 5. CP | inode(x) | dnode(F) | inode(DF) 6. CP | inode(DF) | dnode(F) 7. CP | dnode(F) | inode(DF) 8. CP | dnode(F) | inode(x) | inode(DF) For example, #3, the three conditions should be changed as follows. inode(x) | CP | dnode(F) | inode(x) | inode(F) a) x o o o o b) x x x x o c) x o o x o If f2fs_sync_file stops ------^, it should write inode(F) --------------^ So, the need_inode_block_update should return true, since c) get_nat_flag(e, HAS_LAST_FSYNC), is false. For example, #8, CP | alloc | dnode(F) | inode(x) | inode(DF) a) o x x x x b) x x x o c) o o x o If f2fs_sync_file stops -------^, it should write inode(DF) --------------^ Note that, the roll-forward policy should follow this rule, which means, if there are any missing blocks, we doesn't need to recover that inode. Signed-off-by: Huang Ying <ying.huang@intel.com> Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
2014-09-15 14:50:48 -07:00
f2fs: refactor flush_nat_entries codes for reducing NAT writes Although building NAT journal in cursum reduce the read/write work for NAT block, but previous design leave us lower performance when write checkpoint frequently for these cases: 1. if journal in cursum has already full, it's a bit of waste that we flush all nat entries to page for persistence, but not to cache any entries. 2. if journal in cursum is not full, we fill nat entries to journal util journal is full, then flush the left dirty entries to disk without merge journaled entries, so these journaled entries may be flushed to disk at next checkpoint but lost chance to flushed last time. In this patch we merge dirty entries located in same NAT block to nat entry set, and linked all set to list, sorted ascending order by entries' count of set. Later we flush entries in sparse set into journal as many as we can, and then flush merged entries to disk. In this way we can not only gain in performance, but also save lifetime of flash device. In my testing environment, it shows this patch can help to reduce NAT block writes obviously. In hard disk test case: cost time of fsstress is stablely reduced by about 5%. 1. virtual machine + hard disk: fsstress -p 20 -n 200 -l 5 node num cp count nodes/cp based 4599.6 1803.0 2.551 patched 2714.6 1829.6 1.483 2. virtual machine + 32g micro SD card: fsstress -p 20 -n 200 -l 1 -w -f chown=0 -f creat=4 -f dwrite=0 -f fdatasync=4 -f fsync=4 -f link=0 -f mkdir=4 -f mknod=4 -f rename=5 -f rmdir=5 -f symlink=0 -f truncate=4 -f unlink=5 -f write=0 -S node num cp count nodes/cp based 84.5 43.7 1.933 patched 49.2 40.0 1.23 Our latency of merging op shows not bad when handling extreme case like: merging a great number of dirty nats: latency(ns) dirty nat count 3089219 24922 5129423 27422 4000250 24523 change log from v1: o fix wrong logic in add_nat_entry when grab a new nat entry set. o swith to create slab cache in create_node_manager_caches. o use GFP_ATOMIC instead of GFP_NOFS to avoid potential long latency. change log from v2: o make comment position more appropriate suggested by Jaegeuk Kim. Signed-off-by: Chao Yu <chao2.yu@samsung.com> Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
2014-06-24 09:18:20 +08:00
f2fs: refactor flush_nat_entries codes for reducing NAT writes Although building NAT journal in cursum reduce the read/write work for NAT block, but previous design leave us lower performance when write checkpoint frequently for these cases: 1. if journal in cursum has already full, it's a bit of waste that we flush all nat entries to page for persistence, but not to cache any entries. 2. if journal in cursum is not full, we fill nat entries to journal util journal is full, then flush the left dirty entries to disk without merge journaled entries, so these journaled entries may be flushed to disk at next checkpoint but lost chance to flushed last time. In this patch we merge dirty entries located in same NAT block to nat entry set, and linked all set to list, sorted ascending order by entries' count of set. Later we flush entries in sparse set into journal as many as we can, and then flush merged entries to disk. In this way we can not only gain in performance, but also save lifetime of flash device. In my testing environment, it shows this patch can help to reduce NAT block writes obviously. In hard disk test case: cost time of fsstress is stablely reduced by about 5%. 1. virtual machine + hard disk: fsstress -p 20 -n 200 -l 5 node num cp count nodes/cp based 4599.6 1803.0 2.551 patched 2714.6 1829.6 1.483 2. virtual machine + 32g micro SD card: fsstress -p 20 -n 200 -l 1 -w -f chown=0 -f creat=4 -f dwrite=0 -f fdatasync=4 -f fsync=4 -f link=0 -f mkdir=4 -f mknod=4 -f rename=5 -f rmdir=5 -f symlink=0 -f truncate=4 -f unlink=5 -f write=0 -S node num cp count nodes/cp based 84.5 43.7 1.933 patched 49.2 40.0 1.23 Our latency of merging op shows not bad when handling extreme case like: merging a great number of dirty nats: latency(ns) dirty nat count 3089219 24922 5129423 27422 4000250 24523 change log from v1: o fix wrong logic in add_nat_entry when grab a new nat entry set. o swith to create slab cache in create_node_manager_caches. o use GFP_ATOMIC instead of GFP_NOFS to avoid potential long latency. change log from v2: o make comment position more appropriate suggested by Jaegeuk Kim. Signed-off-by: Chao Yu <chao2.yu@samsung.com> Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
2014-06-24 09:18:20 +08:00
f2fs: refactor flush_nat_entries codes for reducing NAT writes Although building NAT journal in cursum reduce the read/write work for NAT block, but previous design leave us lower performance when write checkpoint frequently for these cases: 1. if journal in cursum has already full, it's a bit of waste that we flush all nat entries to page for persistence, but not to cache any entries. 2. if journal in cursum is not full, we fill nat entries to journal util journal is full, then flush the left dirty entries to disk without merge journaled entries, so these journaled entries may be flushed to disk at next checkpoint but lost chance to flushed last time. In this patch we merge dirty entries located in same NAT block to nat entry set, and linked all set to list, sorted ascending order by entries' count of set. Later we flush entries in sparse set into journal as many as we can, and then flush merged entries to disk. In this way we can not only gain in performance, but also save lifetime of flash device. In my testing environment, it shows this patch can help to reduce NAT block writes obviously. In hard disk test case: cost time of fsstress is stablely reduced by about 5%. 1. virtual machine + hard disk: fsstress -p 20 -n 200 -l 5 node num cp count nodes/cp based 4599.6 1803.0 2.551 patched 2714.6 1829.6 1.483 2. virtual machine + 32g micro SD card: fsstress -p 20 -n 200 -l 1 -w -f chown=0 -f creat=4 -f dwrite=0 -f fdatasync=4 -f fsync=4 -f link=0 -f mkdir=4 -f mknod=4 -f rename=5 -f rmdir=5 -f symlink=0 -f truncate=4 -f unlink=5 -f write=0 -S node num cp count nodes/cp based 84.5 43.7 1.933 patched 49.2 40.0 1.23 Our latency of merging op shows not bad when handling extreme case like: merging a great number of dirty nats: latency(ns) dirty nat count 3089219 24922 5129423 27422 4000250 24523 change log from v1: o fix wrong logic in add_nat_entry when grab a new nat entry set. o swith to create slab cache in create_node_manager_caches. o use GFP_ATOMIC instead of GFP_NOFS to avoid potential long latency. change log from v2: o make comment position more appropriate suggested by Jaegeuk Kim. Signed-off-by: Chao Yu <chao2.yu@samsung.com> Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
2014-06-24 09:18:20 +08:00