media: mt9m114: Avoid a reset low spike during probe()

Browse source

[ Upstream commit 84359d0a5e ]

mt9m114_probe() requests the reset GPIO in output low state:

	sensor->reset = devm_gpiod_get_optional(dev, "reset", GPIOD_OUT_LOW);

and then almost immediately afterwards calls mt9m114_power_on() which does:

		gpiod_set_value(sensor->reset, 1);
		fsleep(duration);
		gpiod_set_value(sensor->reset, 0);

which means that if the reset pin was high before this code runs that
it will very briefly be driven low because of passing GPIOD_OUT_LOW when
requesting the GPIO only to be driven high again possibly directly after
that. Such a very brief driving low of the reset pin may put the chip in
a confused state.

Request the GPIO in high (reset the chip) state instead to avoid this,
turning the initial gpiod_set_value() in mt9m114_power_on() into a no-op.
and the fsleep() ensures that it will stay high long enough to properly
reset the chip.

Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Signed-off-by: Hans de Goede <johannes.goede@oss.qualcomm.com>
Signed-off-by: Sakari Ailus <sakari.ailus@linux.intel.com>
Signed-off-by: Hans Verkuil <hverkuil+cisco@kernel.org>
Signed-off-by: Sasha Levin <sashal@kernel.org>

...

This commit is contained in:

Hans de Goede 2025-12-30 18:03:03 +01:00 • committed by Sasha Levin

parent 461733d83e

commit 22ffbc504a

1 changed files with 1 additions and 1 deletions

Show all changes Ignore whitespace when comparing lines Ignore changes in amount of whitespace Ignore changes in whitespace at EOL

Download patch file Download diff file Expand all files Collapse all files

2

drivers/media/i2c/mt9m114.c

View file