drm/mcde: dsi: Enable clocks in pre_enable() instead of mode_set()

Browse source

The DSI initialization sequence incorrectly assumes that the mode_set()
function of the DRM bridge is always called when (re-)enabling the display.
This is not necessarily the case.

Keeping the device idle in the framebuffer console for a while results
in the display being turned off using the disable() function. However,
as soon as any key is pressed only (pre_)enable() are called.
mode_set() is skipped because the mode has not been changed.

In this case, the DSI HS/LP clocks are never turned back on,
preventing the display from working.

Fix this by moving a part of the initialization sequence from
mode_set() to pre_enable(). Keep most of the video mode setup in
mode_set() since most of the registers are only dependent on the mode
that is set for the panel - there is no need to write them again each
time we re-enable the display.

Signed-off-by: Stephan Gerhold <stephan@gerhold.net>
Tested-by: Linus Walleij <linus.walleij@linaro.org>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Link: https://patchwork.freedesktop.org/patch/msgid/20191106165835.2863-7-stephan@gerhold.net

...

This commit is contained in:

Stephan Gerhold 2019-11-06 17:58:34 +01:00 • committed by Linus Walleij

parent 1f79c60e10

commit 3c5824bdc4

1 changed files with 37 additions and 30 deletions

Show all changes Ignore whitespace when comparing lines Ignore changes in amount of whitespace Ignore changes in whitespace at EOL

Download patch file Download diff file Expand all files Collapse all files

67

drivers/gpu/drm/mcde/mcde_dsi.c

View file