spi: tegra114: assert CS GPIO for every transfer in a message

Browse source

The driver provides its own transfer_one_message() and therefore drives
the chip-select GPIO itself rather than through the SPI core. The GPIO is
asserted only in the is_first_of_msg path of
tegra_spi_setup_transfer_one(), but tegra_spi_transfer_end() deasserts it
whenever a transfer has cs_change set. For a multi-transfer message whose
earlier transfers request cs_change -- for example a register read that
sends the address in one transfer and clocks the data back in the next --
the CS GPIO is released after the first transfer and never re-asserted,
so the remaining transfers are clocked with chip-select inactive and the
peripheral never drives the bus.

This was observed with an ADIS16470 IMU (adis16475 driver), whose
register read is a two-transfer, cs_change-framed exchange: a logic
analyzer showed the data frame clocked with CS high, and the driver read
0 while the device drove 0x4056 on the wire.

Re-assert the CS GPIO for every transfer so that multi-transfer messages
keep chip-select active across the whole message. gpiod_set_value() is
idempotent and polarity-aware, so this is a no-op for the first transfer
and for messages that keep CS asserted throughout.

Fixes: 63c1440596 ("spi: tegra114: add support for gpio based CS")
Signed-off-by: Carlos Jones Jr <carlosjr.jones@analog.com>
Link: https://patch.msgid.link/20261002085540.1625-1-carlosjr.jones@analog.com
Signed-off-by: Mark Brown <broonie@kernel.org>

...

This commit is contained in:

Carlos Jones Jr 2026-10-02 16:55:40 +08:00 • committed by Mark Brown

parent 24a19b953e

commit 8980bc573a

No known key found for this signature in database

GPG key ID: 2FEF73B0B3D03889

1 changed files with 7 additions and 0 deletions

Show all changes Ignore whitespace when comparing lines Ignore changes in amount of whitespace Ignore changes in whitespace at EOL

Download patch file Download diff file Expand all files Collapse all files

7

drivers/spi/spi-tegra114.c

View file