media: i2c: imx283: Fix hang when going from large to small resolution

Browse source

When switching between modes (e.g. full resolution to binned),
standby_cancel() previously cleared XMSTA (starting master mode data
output) before the new mode's MDSEL, crop, and timing registers were
programmed in start_streaming(). This caused the sensor to briefly
output MIPI data using the previous mode's configuration.

On receivers like imx-mipi-csis, this leads to FIFO overflow errors
when switching from a higher to a lower resolution, as the receiver is
configured for the new smaller frame size but receives stale
full-resolution data.

Fix this by moving the XMSTA and SYNCDRV register writes from
standby_cancel() to the end of start_streaming(), after all mode,
crop, and timing registers have been configured. Also explicitly stop
master mode (XMSTA=1) when stopping the stream, matching the pattern
used by other Sony sensor drivers (imx290, imx415).

Use named macros IMX283_XMSTA_START/STOP instead of raw 0/BIT(0) for
readability.

Cc: stable@vger.kernel.org
Fixes: ccb4eb4496 ("media: i2c: Add imx283 camera sensor driver")
Signed-off-by: Jai Luthra <jai.luthra@ideasonboard.com>
Tested-by: Kieran Bingham <kieran.bingham@ideasonboard.com>
Reviewed-by: Kieran Bingham <kieran.bingham@ideasonboard.com>
Signed-off-by: Sakari Ailus <sakari.ailus@linux.intel.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@kernel.org>

...

This commit is contained in:

Jai Luthra 2026-02-14 18:35:22 +05:30 • committed by Mauro Carvalho Chehab

parent bce1349dbf

commit 9206359b2c

1 changed files with 10 additions and 5 deletions

Show all changes Ignore whitespace when comparing lines Ignore changes in amount of whitespace Ignore changes in whitespace at EOL

Download patch file Download diff file Expand all files Collapse all files

15

drivers/media/i2c/imx283.c

View file