mirror of
https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git/
synced 2026-11-17 19:14:47 +00:00
Bluetooth: hci_qca: Fix SSR (SubSystem Restart) fail when BT_EN is pulled up by hw
On QCS9075 and QCA8275 platforms, the BT_EN pin is always pulled up by hw and cannot be controlled by the host. As a result, in case of a firmware crash, the host cannot trigger a cold reset. Instead, the BT controller performs a warm restart on its own, without reloading the firmware. This leads to the controller remaining in IBS_WAKE state, while the host expects it to be in sleep mode. The mismatch causes HCI reset commands to time out. Additionally, the driver does not clear internal flags QCA_SSR_TRIGGERED and QCA_IBS_DISABLED, which blocks the reset sequence. If the SSR duration exceeds 2 seconds, the host may enter TX sleep mode due to tx_idle_timeout, further preventing recovery. Also, memcoredump_flag is not cleared, so only the first SSR generates a coredump. Tell the driver that the BT controller has undergone a proper restart sequence: - Clear QCA_SSR_TRIGGERED and QCA_IBS_DISABLED flags after SSR. - Add a 50ms delay to allow the controller to complete its warm reset. - Reset tx_idle_timer to prevent the host from entering TX sleep mode. - Clear memcoredump_flag to allow multiple coredump captures. Apply these steps only when HCI_QUIRK_NON_PERSISTENT_SETUP is not set, which indicates that BT_EN is defined in DTS and cannot be toggled. Refer to the comment in include/net/bluetooth/hci.h for details on HCI_QUIRK_NON_PERSISTENT_SETUP. Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@oss.qualcomm.com> Signed-off-by: Shuai Zhang <shuai.zhang@oss.qualcomm.com> Signed-off-by: Luiz Augusto von Dentz <luiz.von.dentz@intel.com>
This commit is contained in:
parent
e75e408dc5
commit
fce1a9244a
1 changed files with 33 additions and 0 deletions
Loading…
Add table
Add a link
Reference in a new issue