This is a one-liner to use cond_resched() rather than schedule()
in the ast delivery loop. It should not be necessary to schedule
every time, so this will save some cpu time while continuing to
allow scheduling when required.
Signed-off-by: Steven Whitehouse <swhiteho@redhat.com>
Signed-off-by: David Teigland <teigland@redhat.com>
The pages used in lowcomms are not highmem, so kmap is not necessary.
Cc: Christine Caulfield <ccaulfie@redhat.com>
Signed-off-by: Steven Whitehouse <swhiteho@redhat.com>
Signed-off-by: David Teigland <teigland@redhat.com>
Use ls_allocation for memory allocations, which a cluster fs sets to
GFP_NOFS. Use GFP_NOFS for allocations when no lockspace struct is
available. Taking dlm locks needs to avoid calling back into the
cluster fs because write-out can require taking dlm locks.
Cc: Christine Caulfield <ccaulfie@redhat.com>
Signed-off-by: Steven Whitehouse <swhiteho@redhat.com>
Signed-off-by: David Teigland <teigland@redhat.com>
Removing the beacon cache entry from a uwb_dev can cause an oops if the
bce is released before the call to uwb_notify().
Signed-off-by: Stefano Panella <stefano.panella@csr.com>
Signed-off-by: David Vrabel <david.vrabel@csr.com>
Impact: extend performance counter support on x86 Intel CPUs
Modern Intel CPUs have 3 "fixed-function" performance counters, which
count these hardware events:
Instr_Retired.Any
CPU_CLK_Unhalted.Core
CPU_CLK_Unhalted.Ref
Add support for them to the performance counters subsystem.
Their use is transparent to user-space: the counter scheduler is
extended to automatically recognize the cases where a fixed-function
PMC can be utilized instead of a generic PMC. In such cases the
generic PMC is kept available for more counters.
The above fixed-function events map to these generic counter hw events:
PERF_COUNT_INSTRUCTIONS
PERF_COUNT_CPU_CYCLES
PERF_COUNT_BUS_CYCLES
(The 'bus' cycles are in reality often CPU-ish cycles, just with a fixed
frequency.)
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Generalize "bus cycles" hw events - and map them to CPU_CLK_Unhalted.Ref
on x86. (which is a good enough approximation)
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Impact: clean up and refactor code
refactor the counter scheduler: separate out in/out functions and
introduce a counter-rotation function as well.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Impact: remove dead code
nr_inherited was not maintained correctly (not decremented) - and also
not used - remove it.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Allow lowlevel ->enable() op to return an error if a counter can not be
added. This can be used to handle counter constraints.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Change counter inheritance from a 'push' to a 'pull' model: instead of
child tasks pushing their final counts to the parent, reuse the wait4
infrastructure to pull counters as child tasks are exit-processed,
much like how cutime/cstime is collected.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Enumerate fixed-mode PMCs based on CPUID, and feed that into the
perfcounter code.
Does not use fixed-mode PMCs yet.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Impact: refactor the x86 code for fixed-mode PMCs
Extend the data structures and rename the existing facilities
to allow for a 'generic' versus 'fixed' counter distinction.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Impact: rename include file
We'll be providing an asm/perf_counter.h to the generic perfcounter code,
so use the already existing x86 file for this purpose and rename it.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Impact: schedule in groups atomically
If there are multiple groups in a task, make sure they are scheduled
in and out atomically.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Fix a NULL pointer dereference that would occur if the video decoder tied to
the em28xx supports the VIDIOC_INT_RESET call (for example: the cx25840 driver)
Signed-off-by: Devin Heitmueller <dheitmueller@linuxtv.org>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
When we commit, but before we try to write anything to the flash
media, @c->min_idx_size is inaccurate, because we do not re-calculate
it after the commit. Do not forget to do this.
Signed-off-by: Artem Bityutskiy <Artem.Bityutskiy@nokia.com>
Take into account that 2 eraseblocks are never available because
they are reserved for the index. This gives more realistic count
of FS blocks.
To avoid future confusions like this, introduce a constant.
Signed-off-by: Artem Bityutskiy <Artem.Bityutskiy@nokia.com>
Add support for the built-in touchscreen controller in DA9034
(aka Micco), usually found on platforms with xscale processors.
Signed-off-by: Eric Miao <eric.miao@marvell.com>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
When ACPI is asked to find an MADT (APIC table)
and fails, then ACPI expects to run in PIC mode.
However, if an MP Table is was found, IRQs will be
registered as if an IOAPIC is being used, even
though ACPI is configuring interrupt links links for PIC mode.
In this scenario, disable MPS so that IRQs
are registered in PIC mode, consistent with ACPI.
http://bugzilla.kernel.org/show_bug.cgi?id=12257
Signed-off-by: Len Brown <len.brown@intel.com>
When the napi api was changed to separate its 1:1 binding to the net_device
struct, the netif_rx_[prep|schedule|complete] api failed to remove the now
vestigual net_device structure parameter. This patch cleans up that api by
properly removing it..
Signed-off-by: Neil Horman <nhorman@tuxdriver.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Wire up the trampoline code for ppc32 to relay exceptions from the
vectors at address 0 to vectors at address 32MB, and modify Kconfig
to enable Kdump support for all classic powerpcs.
Signed-off-by: Dale Farnsworth <dale@farnsworth.org>
Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>
Add the ability for a classic ppc kernel to be loaded at an address
of 32MB. This done by fixing a few places that assume we are loaded
at address 0, and by changing several uses of KERNELBASE to use
PAGE_OFFSET, instead.
Signed-off-by: Dale Farnsworth <dale@farnsworth.org>
Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>
While for debugging it is good to catch bogus users of ioremap, though
for kdump support it is more convenient to use __ioremap for
copy_oldmem_page() (exactly as we do for PPC64 currently).
Note that copy_oldmem_page() calls __ioremap with flags set to '0',
so it should be safe with the regard to the caches.
The other option is to use kmap_atomic_pfn()[1], but it will not work
for kernels compiled without HIGHMEM.
That is, on a board with 256MB RAM and crashkernel=64M@32M case, the
!HIGHMEM capturing kernel maps 0-96M range, which does not include all
the memory needed to capture the dump. And, obviously, accessing
anything upper than 96M will cause faults.
[1] http://ozlabs.org/pipermail/linuxppc-dev/2007-November/046747.html
Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>
Refactor the setting of kdump OF properties, moving the common code
from machine_kexec_64.c to machine_kexec.c where it can be used on
both ppc64 and ppc32. This will be needed for kdump to work on ppc32
platforms.
Signed-off-by: Dale Farnsworth <dale@farnsworth.org>
Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>
This replaces the dummy crash_setup_regs function with full-fledged
crash_setup_regs implementation. On PPC32 we simply use the new
ppc_save_regs function to dump the registers.
Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>
Today the arch/powerpc/xmon/setjmp.S file contains only the
xmon_save_regs function. We want to use it for kdump purposes, so
let's move the file into arch/powerpc/kernel/ and give the function a
more generic name (ppc_save_regs).
Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>
This removes the need for each platform to specify default kexec and
crash kernel ops, thus effectively adds a working kexec support for
most 6xx/7xx/7xxx-based boards.
Platforms that can't cope with default ops will explode in some weird
way (a hang or reboot is most likely), which means that the board's
kexec support should be fixed or blacklisted via dummy _prepare
callback returning -ENOSYS.
Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>
