This add support to the SiS and VIA drivers for the simple memory manager.
This fixes a lot of problems with the current simple code these drivers used,
including locking and SMP issues.
Signed-off-by: Dave Airlie <airlied@linux.ie>
This adds the DRM hashtable and simple memory manager implementations from
Tungsten Graphics, this is NOT the new memory manager, this is a replacement
for the SIS and VIA memory managers.
Signed-off-by: Dave Airlie <airlied@linux.ie>
When writeback isn't used, actually disable it in the hardware.
Not doing this might waste bus bandwidth or even cause memory corruption or
system crashes on systems that check bus transfers. No such incident has been
reported though.
Signed-off-by: Dave Airlie <airlied@linux.ie>
When this succeeds, userspace can read the scratch register contents from th mapped writeback page directly.
Signed-off-by: Dave Airlie <airlied@linux.ie>
This patch removes the pci_domain from the DRM device structure, and
gets it via a macro that either asks the platform or does the alpha special
case. jgarzik asked for this to just use the platform magic, but I've no
alpha experience and I'd rather not just break it and wait for someone to
give out.
Signed-off-by: Dave Airlie <airlied@linux.ie>
This patch removes some of the old compatibility macros from the DRM,
and removes use of DRM wrappers from Linux specific code.
Signed-off-by: Dave Airlie <airlied@linux.ie>
The fs_no mean used to be fs_enet driver driven, hence it was an
enumeration across all the possible fs_enet "users" in the SoC. Now, with
QE on the pipeline, and to make DTS descriptions more clear, fs_no features
relevant SoC part number, with additional field to describe the SoC type.
Another reason for that is now not only fs_enet is going to utilize those
stuff. There might be UART, HLDC, and even USB, so to prevent confusion and
be ready for upcoming OF_device transfer, fs_enet and cpm_uart drivers were
updated in that concern, as well as the relevant DTS.
Signed-off-by: Vitaly Bordug <vbordug@ru.mvista.com>
Incorporating the new way of cpm2 immr access, introduced in the previous
patch, into CPM2 peripheral devices (fs_enet and cpm_uart). Both ppc and
powerpc approved working( real actions taken in powerpc only, ppc just
has a wrapper to keep init stuff consistent).
Signed-off-by: Vitaly Bordug <vbordug@ru.mvista.com>
The stuff below cleans up the code attempting to remap the whole cpm2_immr
early, as well as places happily assuming that fact. This is more like the 2.4
legacy stuff, and is at least confusing and unclear now.
To keep the world comfortable, a new mechanism is introduced: before accessing
specific immr register/register set, one needs to map it, using cpm2_map(<reg>),
for instance, access to CPM command register will look like
volatile cpm_cpm2_t *cp = cpm2_map(im_cpm);
keeping the code clear, yet without "already defined somewhere" cpm2_immr.
So far, unmapping code is not implemented, but it's not a big deal to add it,
if the whole idea makes sense.
Signed-off-by: Vitaly Bordug <vbordug@ru.mvista.com>
This makes the 8560 evaluation board fully supported under arch/powerpc,
as the first board with CPM2 SoC peripherals. The brand new devicetree
nodes are introduced (intending to be a subset of the QuiccEngine-equipped
models, with dts sources placed into the kernel according to the new convention.
Assuming all the preceding stuff applied (PAL+fs_enet related+ CPM_UART
update), the both TSEC eth ,FCC Eths, and both SCC UARTs are
working. The relevant drivers are still capable to drive users in ppc,
which was verified with 8272ADS (SCC uart+FCC eth).
This is also verified on mpc8540 and actually make it work (PCI stuff
working as well)
Signed-off-by: Vitaly Bordug <vbordug@ru.mvista.com>
This moves the cpm2 common code and PIC stuff to the powerpc. Most of the files
were just copied from ppc/, with minor tuning to make it compile, and, subsequently, work.
Signed-off-by: Vitaly Bordug <vbordug@ru.mvista.com>
Driver core has been updated to make use of the new powerpc OF-inspired
platform devices, yet keeping compatibility to the vast board list from
ppc.
Signed-off-by: Vitaly Bordug <vbordug@ru.mvista.com>
This patch contains necessary modifications to support the CPM2 SoC peripherals.
For the time being, those are fs_enet Ethernet driver and cpm_uart serial.
Written initially to support mpc8560, it also suites to the part of the large PQ2
(more specifically, mpc8260) family.
Signed-off-by: Vitaly Bordug <vbordug@ru.mvista.com>
This fixes some debug register defines on PPC 40x that were incorrect.
Signed-off-by: Josh Boyer <jdub@us.ibm.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>
Update to the PowerPC PCI error recovery code.
Add code to enable MMIO if a device driver reports that it is capable
of recovering on its own. One anticipated use of this having a device
driver enable MMIO so that it can take a register dump, which might
then be followed by the device driver requesting a full reset.
Signed-off-by: Linas Vepstas <linas@austin.ibm.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>
Add wrapper around the rtas call to enable MMIO or DMA on a frozen pci
slot.
Signed-off-by: Linas Vepstas <linas@austin.ibm.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>
Clean up subroutine documentation; mostly formatting changes, with
some new content.
Signed-off-by: Linas Vepstas <linas@austin.ibm.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>
This corrects a pci_dev get/put imbalance that can occur only in
highly unlikely situations (kmalloc failures, pci devices with
overlapping resource addresses). No actual failures seen, this was
spotted during code review.
Signed-off-by: Linas Vepstas <linas@austin.ibm.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>
The stack frame address was being printed incorrectly in the backtrace
option of XMON on PPC. This patch fixes it to print the actual stack
address instead of the address of the local variable that contains it.
Signed-off-by: Josh Boyer <jdub@us.ibm.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>
Jakub noticed the cputable.c entry for Xilinx Virtex-4 FX was missing
a .platform value, so the AT_PLATFORM value wouldn't be set correctly.
This adds it.
Signed-off-by: Peter Bergner <bergner@vnet.ibm.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>
This fixes most of the issues with exported headers on CRIS, although
we do still need to deal with the asm/arch symlink.
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
Mostly removing files which have no business being used in userspace.
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
> asm-m32r/page.h requires asm-generic/memory_model.h, which does not exist
> asm-m32r/ptrace.h requires asm/m32r.h, which does not exist
> asm-m32r/signal.h requires linux/linkage.h, which does not exist
> asm-m32r/unistd.h requires asm/syscall.h, which does not exist
> asm-m32r/user.h requires asm/processor.h, which does not exist
Signed-off-by: Hirokazu Takata <takata@linux-m32r.org>
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
Cleanup for user headers, as noted:
asm-sh64/page.h requires asm-generic/memory_model.h, which does not exist in exported headers
asm-sh64/shmparam.h requires asm/cache.h, which does not exist in exported headers
asm-sh64/signal.h requires asm/processor.h, which does not exist in exported headers
asm-sh64/user.h requires asm/processor.h, which does not exist in exported headers
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
Cleanup for user headers, as noted:
asm-sh/page.h requires asm-generic/memory_model.h, which does not exist in exported headers
asm-sh/ptrace.h requires asm/ubc.h, which does not exist in exported headers
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
The last minute fix submitted by the author fixed a bug, but
broke the driver build.
Noticed by Al Viro, since I can't build on said platform.
Signed-off-by: Jeff Garzik <jeff@garzik.org>
Just some minor comment nits.
- little-endian is better than low-endian
- and since it is called essiv everywere it should also be essiv
in the comments (and not ess_iv)
Signed-off-by: Rik Snel <rsnel@cube.dyndns.org>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
This patch marks the crypto_digest_* functions and crypto_alg_available
as deprecated. They've been replaced by crypto_hash_* and crypto_has_*
respectively.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
This patch converts padlock-sha to use crypto_hash for its fallback.
It also changes the fallback selection to use selection by type instead
of name. This is done through the new CRYPTO_ALG_NEED_FALLBACK bit,
which is set if and only if an algorithm needs a fallback of the same
type.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
This patch adds the crypto_comp type to complete the compile-time checking
conversion. The functions crypto_has_alg and crypto_has_cipher, etc. are
also added to replace crypto_alg_available.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
