Remove the function kgdb_post_primary_code() that is not used anywhere.
This was partially found by using a static code analysis program called cppcheck.
Signed-off-by: Rickard Strandqvist <rickard_strandqvist@spectrumdigital.se>
Acked-by: Sonic Zhang <sonic.zhang@analog.com>
Rework of the prandom device with introduction of a new SHA-512 based
NIST SP 800-90 conform deterministic random bit generator.
Signed-off-by: Harald Freudenberger <freude@linux.vnet.ibm.com>
Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>
After the file ptes have been removed the bit combination used to
encode non-linear mappings can be reused for the swap ptes. This
frees up a precious pte software bit. Reflect the change in the
swap encoding in the comments and do some cleanup while we are
at it.
Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>
The dirty & young bit from the pmd is not copied correctly to the
pseudo pte in __pmd_to_pte. In fact it is not copied at all, the
bits get lost. As the old style huge page currently does not need
the dirty & young information this has no effect, but may be needed
in the future.
Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>
The new ebpf code uses e.g. the laal instruction which is part of the
interlocked-access facility 1 which again was introduced with z196.
So we must make sure the ebpf code generator depends on MARCH_Z196_FEATURES.
Signed-off-by: Heiko Carstens <heiko.carstens@de.ibm.com>
If one memory allocation fails, there is a memory leak.
Signed-off-by: Christophe Jaillet <christophe.jaillet@wanadoo.fr>
Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>
Replacing a 2K page table with a 4K page table while a VMA is active
for the affected memory region is fundamentally broken. Rip out the
page table reallocation code and replace it with a simple system
control 'vm.allocate_pgste'. If the system control is set the page
tables for all processes are allocated as full 4K pages, even for
processes that do not need it.
Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>
Introduce KEXEC_CONTROL_MEMORY_GFP to allow the architecture code
to override the gfp flags of the allocation for the kexec control
page. The loop in kimage_alloc_normal_control_pages allocates pages
with GFP_KERNEL until a page is found that happens to have an
address smaller than the KEXEC_CONTROL_MEMORY_LIMIT. On systems
with a large memory size but a small KEXEC_CONTROL_MEMORY_LIMIT
the loop will keep allocating memory until the oom killer steps in.
Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>
My conversion of the mac80211 station hash table to rhashtable
completely broke the lookup in sta_info_get() as it no longer
took into account the virtual interface. Fix that.
Fixes: 7bedd0cfad ("mac80211: use rhashtable for station table")
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Sometimes it fails to wake up from suspend to RAM, this is because
we would flush the data cache by assemble command FLUSHINV before
suspend to RAM, and there is a delay between this command execution
and cache flush completion. Add a 1uS delay to works around this.
Signed-off-by: Aaron Wu <Aaron.wu@analog.com>
Interacting with the USB_PHY_TEST MMR through debugfs was causing wide-spread
chaos in the realm (kernel panic). Expunge all references to this demonic
register.
Signed-off-by: Andre Wolokita <Andre.Wolokita@analog.com>
Replacing strncpy with strlcpy to avoid strings that lacks null terminate.
Signed-off-by: Rickard Strandqvist <rickard_strandqvist@spectrumdigital.se>
Signed-off-by: Steven Miao <realmz6@gmail.com>
For platforms that don't support DT, some early MFD modules can register
lookup tables. Remove the __init annotation so that this works. This is
similar to gpio_add_lookup_table() which allows late additions.
CC: Samuel Ortiz <sameo@linux.intel.com>
Cc: Linus Walleij <linus.walleij@linaro.org>
Cc: Alexandre Courbot <gnurou@gmail.com>
Cc: Thierry Reding <thierry.reding@gmail.com>
Signed-off-by: Shobhit Kumar <shobhit.kumar@intel.com>
Signed-off-by: Thierry Reding <thierry.reding@gmail.com>
The return value of hrtimer_start() tells whether the timer was
inactive or active already when hrtimer_start() was called.
The code emits a bogus warning if the timer was active already
claiming that the timer could not be started.
Remove it along with the bogus comment in the else path.
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Acked-by: Frans Klaver <frans.klaver@xsens.com>
Cc: Sebastian Reichel <sre@kernel.org>
Cc: Dmitry Eremin-Solenikov <dbaryshkov@gmail.com>
Cc: David Woodhouse <dwmw2@infradead.org>
Cc: Wolfram Sang <wsa@the-dreams.de>
Cc: linux-pm@vger.kernel.org
The struct member is gone.
Reported-by: fengguang.wu@intel.com>
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Cc: Peter Zijlstra <peterz@infradead.org>
Switch default pcbeep path to Line in path.
Signed-off-by: Kailang Yang <kailang@realtek.com>
Tested-by: Hui Wang <hui.wang@canonical.com>
Cc: <stable@vger.kernel.org>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
If xfrm_*_register_afinfo failed since xfrm_*_afinfo[afinfo->family] had the
value, return the -EEXIST, not -ENOBUFS
Signed-off-by: Li RongQing <roy.qing.li@gmail.com>
Signed-off-by: Steffen Klassert <steffen.klassert@secunet.com>
The walk from input is the list header, and marked as dead, and will
be skipped in loop.
list_first_entry() can be used to return the true usable value from
walk if walk is not empty
Signed-off-by: Li RongQing <roy.qing.li@gmail.com>
Acked-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: Steffen Klassert <steffen.klassert@secunet.com>
The task of xfrm_queue_purge is same as skb_queue_purge, so remove it
Signed-off-by: Li RongQing <roy.qing.li@gmail.com>
Signed-off-by: Steffen Klassert <steffen.klassert@secunet.com>
This has the benefit that the "optimization" of the framework in regards
to spi_sync will also benefit spidev users directly and allow running
spi transfers without a necessary context-switch to message-pump.
Signed-off-by: Martin Sperl <kernel@martin.sperl.org>
Signed-off-by: Mark Brown <broonie@kernel.org>
The tom code should be using SND_SST_MFLD_PLATFORM and not the baytrail one.
So fix it now
Signed-off-by: Vinod Koul <vinod.koul@intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Using GPIOs and gpiolib is optional. If the kernel is compiled without GPIO
support the driver should not fail if it finds the interrupt using normal
methods.
However, commit a485923efb ("HID: i2c-hid: Add support for ACPI GPIO
interrupts") did not take into account that acpi_dev_add_driver_gpios()
returns -ENXIO when !CONFIG_GPIOLIB.
Fix this by checking the return value against -ENXIO and 0 and only in that
case fail the probe.
Reported-by: Gabriele Mazzotta <gabriele.mzt@gmail.com>
Signed-off-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
Set flags INPUT_PROP_POINTER and INPUT_PROP_POINTING_STICK for the trackpoint
integrated in Lenovo USB and Bluetooth keyboards. Libinput checks these flags
to enable features such as middle-button-scrolling by default.
Signed-off-by: Andreas Fleig <andreasfleig@gmail.com>
Reviewed-by: Benjamin Tissoires <benjamin.tissoires@redhat.com>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
To determine if a touch is present in the single-touch case, we can
simply check if the BTN_TOUCH key is active or not. This will work for
both HID_GENERIC and other device types.
Signed-off-by: Jason Gerecke <jason.gerecke@wacom.com>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
We use generic hid_report_len() to get individual packet length now.
Signed-off-by: Ping Cheng <pingc@wacom.com>
Reviewed-by: Jason Gerecke <jason.gerecke@wacom.com>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
That is where they belong...
Signed-off-by: Ping Cheng <pingc@wacom.com>
Reviewed-by: Jason Gerecke <jason.gerecke@wacom.com>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
It makes probe routine easy to follow.
Signed-off-by: Ping Cheng <pingc@wacom.com>
Reviewed-by: Jason Gerecke <jason.gerecke@wacom.com>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
This fix the below build error
arch/powerpc/mm/hash_utils_64.c: In function ‘flush_hash_hugepage’:
arch/powerpc/mm/hash_utils_64.c:1381:1: error: label at end of compound statement
tm_abort:
^
make[1]: *** [arch/powerpc/mm/hash_utils_64.o] Error 1
Reported-by: Anshuman Khandual <khandual@linux.vnet.ibm.com>
Signed-off-by: Aneesh Kumar K.V <aneesh.kumar@linux.vnet.ibm.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>
All users of AEAD should include crypto/aead.h instead of
include/linux/crypto.h.
This patch also removes a bogus inclusion of algapi.h which should
only be used by algorithm/driver implementors and not crypto users.
Instead linux/crypto.h is added which is necessary because mac802154
also uses blkcipher in addition to aead.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Acked-by: David S. Miller <davem@davemloft.net>
All users of AEAD should include crypto/aead.h instead of
include/linux/crypto.h.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Acked-by: David S. Miller <davem@davemloft.net>
All users of AEAD should include crypto/aead.h instead of
include/linux/crypto.h.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Acked-by: David S. Miller <davem@davemloft.net>
All users of AEAD should include crypto/aead.h instead of
include/linux/crypto.h.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Acked-by: David S. Miller <davem@davemloft.net>
All users of AEAD should include crypto/aead.h instead of
include/linux/crypto.h.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Acked-by: David S. Miller <davem@davemloft.net>
All implementers of AEAD should include crypto/internal/aead.h
instead of include/linux/crypto.h.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Acked-by: David S. Miller <davem@davemloft.net>
Now that all fips_enabled users are including linux/fips.h directly
instead of getting it through internal.h, we can remove the fips.h
inclusions from internal.h.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
All users of fips_enabled should include linux/fips.h directly
instead of getting it through internal.h.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
All users of fips_enabled should include linux/fips.h directly
instead of getting it through internal.h which is reserved for
internal crypto API implementors.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
There is currently a large ifdef FIPS code section in proc.c.
Ostensibly it's there because the fips_enabled sysctl sits under
/proc/sys/crypto. However, no other crypto sysctls exist.
In fact, the whole ethos of the crypto API is against such user
interfaces so this patch moves all the FIPS sysctl code over to
fips.c.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
