mirror of
https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git/
synced 2026-09-28 19:20:30 +00:00
No description
- C 96.9%
- Assembly 0.9%
- Rust 0.6%
- Shell 0.6%
- Python 0.5%
- Other 0.3%
d7d0d389ff
Patch series "Swap-out mTHP without splitting", v7.
This series adds support for swapping out multi-size THP (mTHP) without
needing to first split the large folio via
split_huge_page_to_list_to_order(). It closely follows the approach
already used to swap-out PMD-sized THP.
There are a couple of reasons for swapping out mTHP without splitting:
- Performance: It is expensive to split a large folio and under
extreme memory pressure some workloads regressed performance when
using 64K mTHP vs 4K small folios because of this extra cost in the
swap-out path. This series not only eliminates the regression but
makes it faster to swap out 64K mTHP vs 4K small folios.
- Memory fragmentation avoidance: If we can avoid splitting a large
folio memory is less likely to become fragmented, making it easier to
re-allocate a large folio in future.
- Performance: Enables a separate series [7] to swap-in whole mTHPs,
which means we won't lose the TLB-efficiency benefits of mTHP once the
memory has been through a swap cycle.
I've done what I thought was the smallest change possible, and as a
result, this approach is only employed when the swap is backed by a
non-rotating block device (just as PMD-sized THP is supported today).
Discussion against the RFC concluded that this is sufficient.
Performance Testing
===================
I've run some swap performance tests on Ampere Altra VM (arm64) with 8
CPUs. The VM is set up with a 35G block ram device as the swap device and
the test is run from inside a memcg limited to 40G memory. I've then run
`usemem` from vm-scalability with 70 processes, each allocating and
writing 1G of memory. I've repeated everything 6 times and taken the mean
performance improvement relative to 4K page baseline:
| alloc size | baseline | + this series |
| | mm-unstable (~v6.9-rc1) | |
|:-----------|------------------------:|------------------------:|
| 4K Page | 0.0% | 1.3% |
| 64K THP | -13.6% | 46.3% |
| 2M THP | 91.4% | 89.6% |
So with this change, the 64K swap performance goes from a 14% regression to a
46% improvement. While 2M shows a small regression I'm confident that this is
just noise.
[1] https://lore.kernel.org/linux-mm/20231010142111.3997780-1-ryan.roberts@arm.com/
[2] https://lore.kernel.org/linux-mm/20231017161302.2518826-1-ryan.roberts@arm.com/
[3] https://lore.kernel.org/linux-mm/20231025144546.577640-1-ryan.roberts@arm.com/
[4] https://lore.kernel.org/linux-mm/20240311150058.1122862-1-ryan.roberts@arm.com/
[5] https://lore.kernel.org/linux-mm/20240327144537.4165578-1-ryan.roberts@arm.com/
[6] https://lore.kernel.org/linux-mm/20240403114032.1162100-1-ryan.roberts@arm.com/
[7] https://lore.kernel.org/linux-mm/20240304081348.197341-1-21cnbao@gmail.com/
[8] https://lore.kernel.org/linux-mm/CAGsJ_4yMOow27WDvN2q=E4HAtDd2PJ=OQ5Pj9DG+6FLWwNuXUw@mail.gmail.com/
[9] https://lore.kernel.org/linux-mm/579d5127-c763-4001-9625-4563a9316ac3@redhat.com/
This patch (of 7):
As preparation for supporting small-sized THP in the swap-out path,
without first needing to split to order-0, Remove the CLUSTER_FLAG_HUGE,
which, when present, always implies PMD-sized THP, which is the same as
the cluster size.
The only use of the flag was to determine whether a swap entry refers to a
single page or a PMD-sized THP in swap_page_trans_huge_swapped(). Instead
of relying on the flag, we now pass in order, which originates from the
folio's order. This allows the logic to work for folios of any order.
The one snag is that one of the swap_page_trans_huge_swapped() call sites
does not have the folio. But it was only being called there to shortcut a
call __try_to_reclaim_swap() in some cases. __try_to_reclaim_swap() gets
the folio and (via some other functions) calls
swap_page_trans_huge_swapped(). So I've removed the problematic call site
and believe the new logic should be functionally equivalent.
That said, removing the fast path means that we will take a reference and
trylock a large folio much more often, which we would like to avoid. The
next patch will solve this.
Removing CLUSTER_FLAG_HUGE also means we can remove split_swap_cluster()
which used to be called during folio splitting, since
split_swap_cluster()'s only job was to remove the flag.
Link: https://lkml.kernel.org/r/20240408183946.2991168-1-ryan.roberts@arm.com
Link: https://lkml.kernel.org/r/20240408183946.2991168-2-ryan.roberts@arm.com
Signed-off-by: Ryan Roberts <ryan.roberts@arm.com>
Reviewed-by: "Huang, Ying" <ying.huang@intel.com>
Acked-by: Chris Li <chrisl@kernel.org>
Acked-by: David Hildenbrand <david@redhat.com>
Cc: Barry Song <21cnbao@gmail.com>
Cc: Gao Xiang <xiang@kernel.org>
Cc: Kefeng Wang <wangkefeng.wang@huawei.com>
Cc: Lance Yang <ioworker0@gmail.com>
Cc: Matthew Wilcox (Oracle) <willy@infradead.org>
Cc: Michal Hocko <mhocko@suse.com>
Cc: Yang Shi <shy828301@gmail.com>
Cc: Yu Zhao <yuzhao@google.com>
Cc: Barry Song <v-songbaohua@oppo.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
|
History
|
|
|---|---|---|
| arch | ||
| block | ||
| certs | ||
| crypto | ||
| Documentation | ||
| drivers | ||
| fs | ||
| include | ||
| init | ||
| io_uring | ||
| ipc | ||
| kernel | ||
| lib | ||
| LICENSES | ||
| mm | ||
| net | ||
| rust | ||
| samples | ||
| scripts | ||
| security | ||
| sound | ||
| tools | ||
| usr | ||
| virt | ||
| .clang-format | ||
| .cocciconfig | ||
| .editorconfig | ||
| .get_maintainer.ignore | ||
| .gitattributes | ||
| .gitignore | ||
| .mailmap | ||
| .rustfmt.toml | ||
| COPYING | ||
| CREDITS | ||
| Kbuild | ||
| Kconfig | ||
| MAINTAINERS | ||
| Makefile | ||
| README | ||
Linux kernel
============
There are several guides for kernel developers and users. These guides can
be rendered in a number of formats, like HTML and PDF. Please read
Documentation/admin-guide/README.rst first.
In order to build the documentation, use ``make htmldocs`` or
``make pdfdocs``. The formatted documentation can also be read online at:
https://www.kernel.org/doc/html/latest/
There are various text files in the Documentation/ subdirectory,
several of them using the reStructuredText markup notation.
Please read the Documentation/process/changes.rst file, as it contains the
requirements for building and running the kernel, and information about
the problems which may result by upgrading your kernel.